VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
7.1. Coupling
7.2. A transmission
7.3. Kardannaja transfer
7.4. The back bridge
7.4.1. Features of the device
7.4.2. Removal and installation of the back bridge
7.4.3. Dismantling and assemblage of the back bridge
7.4.4. Check of a beam of the back bridge
7.4.5. Editing of a beam of the back bridge
7.4.6. Semiaxes
7.4.7. A reducer
7.4.7.1. Definition of malfunctions of a reducer on noise
7.4.7.2. Reducer removal
7.4.7.3. Reducer installation
7.4.7.4. Reducer dismantling
7.4.7.5. Check of a technical condition of details of a reducer
7.4.7.6. Reducer assemblage
7.4.8. Differential assemblage
7.4.9. Installation and adjustment of a leading gear wheel
7.4.10. Adjustment of bearings of a leading gear wheel
7.4.11. Installation of a box of differential
7.4.12. A tightness of bearings of a box of differential and adjustment of a lateral backlash
7.4.13. Check of contact of teeths of gear wheels of the main transfer
7.4.14. Replacement of an epiploon of a leading gear wheel
7.4.15. Possible malfunctions of the back bridge
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386







7-4-7-3-ustanovka-reduktora.html

7.4.7.3. Reducer installation

Before installation of a reducer a bridge beam carefully clear of oil.

PERFORMANCE ORDER
1. Put on привалочную a surface a sealing lining, insert a reducer into a beam and fix bolts. A carving of bolts preliminary grease with hermetic. Before drawing of hermetic bolts and apertures in a beam carefully degrease. Attach карданный a shaft to a reducer. Establish semiaxes and brake drums.
2. Establish a wheel with the tyre and screw, without a tightening, bolts of fastening of a wheel. Having put both wheels, remove supports and lower the car; then tighten bolts of fastening of wheels динамометрическим a key.
3. Through маслоналивное an aperture fill a beam of the bridge with oil, preliminary having cleared and having screwed in a beam a drain magnetic stopper.

«The previous page
7.4.7.2. Reducer removal
The following page»
7.4.7.4. Reducer dismantling