VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
7.1. Coupling
7.2. A transmission
7.3. Kardannaja transfer
7.4. The back bridge
7.4.1. Features of the device
7.4.2. Removal and installation of the back bridge
7.4.3. Dismantling and assemblage of the back bridge
7.4.4. Check of a beam of the back bridge
7.4.5. Editing of a beam of the back bridge
7.4.6. Semiaxes
7.4.7. A reducer
7.4.8. Differential assemblage
7.4.9. Installation and adjustment of a leading gear wheel
7.4.10. Adjustment of bearings of a leading gear wheel
7.4.11. Installation of a box of differential
7.4.12. A tightness of bearings of a box of differential and adjustment of a lateral backlash
7.4.13. Check of contact of teeths of gear wheels of the main transfer
7.4.14. Replacement of an epiploon of a leading gear wheel
7.4.15. Possible malfunctions of the back bridge
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386




7-4-3-razborka-i-sborka-zadnego-mosta.html

7.4.3. Dismantling and assemblage of the back bridge

Выпрессовка semiaxes by means of a stripper 67.7801.9516

1 – полуось;

2 – a shock stripper

Dismantling

PERFORMANCE ORDER
1. Remove from the bridge the pipeline with a tee of brake system, having disconnected thus the ends of tubes from brake wheel cylinders.
2. Establish the bridge at the stand for repair and merge oil from картера.
3. Having removed a brake drum and having turned away a nut of fastening of a board of a brake, a stripper 2 take out полуось 1, in gathering with маслоотражателем, a plate of fastening of the bearing of a semiaxis, the bearing and запорным a ring. Remove a board of a brake and a sealing ring. In need of replacement, take out an epiploon from a flange of a beam of the bridge.
4. Execute the same operations on other end of a beam, then remove a reducer.

Assemblage

PERFORMANCE ORDER
1. Assemblage of the back bridge spend in sequence, return dismantling. Thus:
      – A carving of bolts of fastening of a reducer grease with hermetic, preliminary having degreased their carving apertures in a beam of the back bridge;
      – An epiploon of the bearing of a semiaxis before installation cover with greasing ЛИТОЛ-24;
      – At epiploon installation in a beam flange use оправкой А.70157;
      – Grease with graphite greasing or greasing ЛСЦ-15 a landing corbel of a flange of a semiaxis under a brake drum and a surface of a flange of the semiaxis, adjoining to a drum.
2. Brake drums establish after installation of the back bridge on the car and fastenings on levers of a drive of a lay brake of tips of a cable.

«The previous page
7.4.2. Removal and installation of the back bridge
The following page»
7.4.4. Check of a beam of the back bridge