VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
7.1. Coupling
7.2. A transmission
7.3. Kardannaja transfer
7.4. The back bridge
7.4.1. Features of the device
7.4.2. Removal and installation of the back bridge
7.4.3. Dismantling and assemblage of the back bridge
7.4.4. Check of a beam of the back bridge
7.4.5. Editing of a beam of the back bridge
7.4.6. Semiaxes Removal and installation Check of a technical condition Removal запорного rings Semiaxis assemblage Gauging of an axial free wheeling of a semiaxis on the car
7.4.7. A reducer
7.4.8. Differential assemblage
7.4.9. Installation and adjustment of a leading gear wheel
7.4.10. Adjustment of bearings of a leading gear wheel
7.4.11. Installation of a box of differential
7.4.12. A tightness of bearings of a box of differential and adjustment of a lateral backlash
7.4.13. Check of contact of teeths of gear wheels of the main transfer
7.4.14. Replacement of an epiploon of a leading gear wheel
7.4.15. Possible malfunctions of the back bridge
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7-4-6-3-snyatie-zapornogo-kolca.html Removal запорного rings

To remove and establish запорное a ring of the bearing of a semiaxis it is necessary only by means of a hydraulic press.

1. Adaptation A.74108/R half rings capture the bearing and establish полуось vertically so that half rings leant against a persistent ring.
2. Put under a press полуось 2 and put on шлицевой the semiaxis end, gradually increasing effort, before removal запорного bearing rings (1 – adaptation A.74108/R). A zapornoe ring of the bearing of a semiaxis repeatedly do not use, and replace new.
3. Check up, whether the landing surface of a semiaxis рисок or damages has; if necessary, replace полуось new.

«The previous page Check of a technical condition
The following page» Semiaxis assemblage