7-1-4-snyatie-i-ustanovka-scepleniya.html
7.1.4. Removal and coupling installationCentering of a conducted disk of coupling with the help оправки А.70081
|
1 – a flywheel;
2 – coupling in gathering;
3 – оправка А.70081
|
PERFORMANCE ORDER |
1. Preliminary remove a transmission (subsection 7.2.2 see). Turn away bolts and remove a coupling casing in gathering with a press disk. Thus, it is impossible to lift this knot for a persistent flange of a press spring. |
2. Coupling installation is made upside-down, thus:
– Check up a bearing condition in an end face of a cranked shaft of the engine, if necessary, replace the bearing;
– Check up a condition шлицев on a nave of a conducted disk and primary to a transmission shaft, шлицы clear and grease with a thin layer консистентной greasings ЛСЦ-15 or ЛИТОЛ-24;
– Arrange a conducted disk acting part of a nave with a ring flute towards a transmission and centre a disk concerning the bearing оправкой А.70081, simulating шлицевой the end of a primary shaft of a transmission. |
|
|
|