VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
7.1. Coupling
7.1.1. Features of the device
7.1.2. Adjustment of a drive of deenergizing of coupling
7.1.3. Prorolling of a hydrodrive of coupling
7.1.4. Removal and coupling installation
7.1.5. The coupling control
7.1.6. Removal and installation of the worker and the main thing of cylinders of a drive of coupling
7.1.7. Dismantling, the control, repair and assemblage of the main thing and the worker of cylinders
7.1.8. Check of the main cylinder of a drive of coupling at the stand
7.1.9. Possible malfunctions of coupling, their reason and elimination methods
7.2. A transmission
7.3. Kardannaja transfer
7.4. The back bridge
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices



7.1.3. Prorolling of a hydrodrive of coupling

About air in a coupling hydrodrive tells incomplete deenergizing of coupling, and also "softness" of a pedal of coupling.

Removal of air from a hydrodrive

1. Clear a tank and the union for prorolling of a dust and a dirt.
2. Check up liquid level in a tank of a hydrodrive and if necessary add a liquid.
3. Put on a head of the union 9 (fig. the Working cylinder and a plug of deenergizing of coupling) the working cylinder a hose see and ship its bottom end in a vessel with a liquid for a hydrodrive (30-50).
4. Sharply press 3–5 times a pedal of coupling with intervals between pressing 2–3 with and, keeping a pedal in the pressed position, turn away the union 9 on 1/2–3/4 turns, superseding pressing a pedal a liquid being in system together with air through a hose in a vessel.
5. After the coupling pedal will reach extreme forward position and the liquid expiration through a hose will stop, wrap the union to the full.
6. Repeat the specified operations to a full exit of vials from a hose.
7. Holding a pedal of coupling pressed, wrap the union against the stop and remove a hose, put on a cap the union, preliminary having wiped it dry.

At prorolling watch liquid level in a hydrodrive tank. It should be above an aperture of the tube connecting a tank with the main cylinder of coupling. The end of a hose for prorolling should be constantly shipped in a liquid.

After prorolling finish liquid level in a tank to the bottom edge of a jellied mouth.

If, despite long prorolling, the hose leaves air vials, check up reliability of fastening of connections, find out, whether is not present on tubes of cracks or подтекания in connections with unions. Air penetration through the damaged sealing rings of the main thing or the worker of cylinders is possible.
The previous page
7.1.2. Adjustment of a drive of deenergizing of coupling
The following page
7.1.4. Removal and coupling installation