VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
3.1. Features of the device
3.2. Possible malfunctions of the engine, their reason and elimination methods
3.3. Removal and engine installation
3.4. Engine dismantling
3.5. Engine assemblage
3.6. Bench tests of the engine
3.7. Engine check on the car
3.8. The block of cylinders
3.9. Pistons and rods
3.10. A cranked shaft and a flywheel
3.11. A head of cylinders and клапанный the mechanism
3.11.1. Features of the device
3.11.2. Removal and installation on the car
3.11.3. Dismantling and assemblage
3.11.4. Clearing of a head of cylinders
3.11.5. Check and grinding of saddles of valves
3.11.6. Valves
3.11.7. Directing plugs of valves
3.11.8. Maslootrazhatelnye caps of directing plugs
3.11.9. Levers of valves
3.11.10. Springs
3.11.11. A lining of a head of cylinders
3.11.12. Check of tightness of a head of cylinders
3.12. A camshaft and its drive
3.13. Cooling system
3.14. Greasing system
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386




3-11-3-razborka-i-sborka.html

3.11.3. Dismantling and assemblage

Details клапанного the mechanism

1 – the valve;
2 – a lock ring;
3 – the directing plug;
4 – маслоотражательный a cap;
5 – a basic washer of an external spring;
6 – a basic washer of an internal spring;
7 – an internal spring;
8 – an external spring;
9 – a plate of springs;
10 – crackers;
11 – the lever of a drive of the valve;
12 – a lever spring;
13 – an adjusting bolt;
14 – a counternut of an adjusting bolt;
15 – the plug of an adjusting bolt;
16 – a lock plate of a spring of the lever

PERFORMANCE ORDER
1. Establish a head of cylinders on board А.60335.
2. Disconnect a final collector and the inlet pipeline with the carburettor (simultaneously leaves заборник hot air).
3. Disconnect a final branch pipe of a cooling shirt.
4. Disconnect a branch pipe of tap of a liquid to a heater.
5. Remove levers 11 (Detail fig. клапанного the mechanism see) valves, releasing them from springs 12. Remove springs of levers.
6. Ослабьте counternuts 14, turn out adjusting bolts 13 and plugs of 15 adjusting bolts.
7. Establish adaptation A.60311/R, compress springs of valves and release crackers (1 – adaptation A.60311/R; 2 – assembly board А.60335). Instead of portable adaptation A.60311/R it is possible to apply also the stationary adaptation 02.7823.9505.
8. Remove springs of valves with plates and basic washers.
9. Turn a head of cylinders and take out from the bottom party valves.
10. Remove маслоотражательные caps from directing plugs.
11. Collect a head of cylinders in return sequence.

«The previous page
3.11.2. Removal and installation on the car
The following page»
3.11.4. Clearing of a head of cylinders