VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
3.1. Features of the device
3.2. Possible malfunctions of the engine, their reason and elimination methods
3.3. Removal and engine installation
3.4. Engine dismantling
3.5. Engine assemblage
3.6. Bench tests of the engine
3.7. Engine check on the car
3.8. The block of cylinders
3.9. Pistons and rods
3.10. A cranked shaft and a flywheel
3.11. A head of cylinders and клапанный the mechanism
3.12. A camshaft and its drive
3.13. Cooling system
3.13.1. Features of the device
3.13.2. Check of level and liquid density in cooling system
3.13.3. Refuelling of system of cooling by a liquid
3.13.4. Adjustment of a tension of a belt of a drive of the pump
3.13.5. The pump of a cooling liquid
3.13.6. The thermostat
3.13.7. A radiator
3.14. Greasing system
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386




3-13-3-zapravka-sistemy-okhlazhdeniya-zhidkostyu.html

3.13.3. Refuelling of system of cooling by a liquid

Refuelling is made at change of a cooling liquid or after engine repair.

PERFORMANCE ORDER
1. Remove stoppers from a radiator and a broad tank, open the heater crane.
2. Fill in cooling liquid (9,85) in a radiator (the liquid is filled in until it will not pour out from a mouth) and put into place a radiator stopper.
3. Add the remained liquid in a broad tank and close its stopper.
4. Start the engine and allow to it to work idling 1–2 mines for removal of air stoppers.
5. After engine cooling check up level of a cooling liquid. If level below normal, and in system of cooling is not present traces подтекания add a liquid.

«The previous page
3.13.2. Check of level and liquid density in cooling system
The following page»
3.13.4. Adjustment of a tension of a belt of a drive of the pump