VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
3.1. Features of the device
3.2. Possible malfunctions of the engine, their reason and elimination methods
3.3. Removal and engine installation
3.4. Engine dismantling
3.5. Engine assemblage
3.6. Bench tests of the engine
3.7. Engine check on the car
3.8. The block of cylinders
3.9. Pistons and rods
3.10. A cranked shaft and a flywheel
3.11. A head of cylinders and клапанный the mechanism
3.12. A camshaft and its drive
3.12.1. Features of the device
3.12.2. Backlash adjustment between levers and camshaft cams
3.12.3. Adjustment of a tension of a chain
3.12.4. Camshaft check
3.12.5. Check of the case of bearings of a camshaft
3.12.6. Натяжитель
3.12.7. A chain of a drive of a camshaft
3.13. Cooling system
3.14. Greasing system
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices



3.12.6. Натяжитель

Specification for spring check натяжителя

Dismantling and assemblage

1. For dismantling натяжителя chains remove колпачковую fixing nut 1 (fig. the Cut натяжителя chains), a tightening cracker 9 and a spring ring 4 see, then take out плунжер 7, a spring 5 and a core 3 together with a spring 8 and a washer 6.
2. Assemblage make upside-down.

The control

1. Check up, whether is not present on crackers 9 and on a core 3 задиров, and on interfaced surfaces of a boot and плунжера натяжителя a chain deep рисок. The damaged details replace.
2. Elasticity of a spring натяжителя should be in the limits specified in fig. the Specification for check of a spring натяжителя; at smaller elasticity a spring replace.
3. Check up, whether there is no raised deterioration on a boot and успокоителе; if it is necessary, replace them.

«The previous page
3.12.5. Check of the case of bearings of a camshaft
The following page»
3.12.7. A chain of a drive of a camshaft