VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
10.1. Features of the device
10.2. Check and adjustment of brakes
10.3. An arm of pedals of coupling and a brake
10.4. The main cylinder
10.5. Forward brakes
10.6. Back brakes
10.6.1. Removal and dismantling
10.6.2. Assemblage and installation
10.6.3. Check of details
10.6.4. Check of wheel cylinders of back brakes at the stand
10.7. A regulator of pressure of back brakes
10.8. A lay brake
10.9. Possible malfunctions of brakes, their reasons and elimination methods
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386







10-6-1-snyatie-i-razborka.html

10.6.1. Removal and dismantling


The brake mechanism of a back wheel


1 – the wheel cylinder;
2 – the lever of a manual drive колодок;
3 – колодка brakes;
4 – a cup and a basic rack колодок;
5 – a cable of a drive of a lay brake with a cover;
6 – the bottom coupling spring;
7 – a frictional overlay;
8 – the clown of adjustment of a backlash between колодкой and a drum;
9 – распорная a lath;
10 – the top coupling spring

PERFORMANCE ORDER
1. Lift a back part of the car and remove a wheel. Take the measures which are not supposing leak of a liquid from a tank.
2. Remove a brake drum, having turned away fixing bolts 1. Insert these bolts into technological apertures 2 and turn to drum branch.
3. Disconnect from the lever 2 (fig. the Brake mechanism of a back wheel see) manual drive колодок the end of a cable 5.
4. Establish on the wheel cylinder adaptation A.72236 for fixation of pistons in the cylinder.
5. Disconnect top 10 and the bottom 6 coupling springs.
6. Having turned cups of basic racks, remove them together with racks, springs and the bottom cups; remove колодки and распорную a lath 9.
7. Remove шплинт, press a finger and remove the lever 2.
8. Disconnect from the wheel cylinder a tube of a supply of a brake liquid and muffle entrance apertures of the cylinder and a tube.
9. Remove the wheel cylinder and adaptation A.72236.
10. At replacement of a brake board remove полуось as it is specified in subsection 7.4.6.1, and disconnect a cable of a drive of a lay brake, having turned out two bolts of fastening to a brake board.

«The previous page
10.6. Back brakes
The following page»
10.6.2. Assemblage and installation