VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
10.1. Features of the device
10.2. Check and adjustment of brakes
10.3. An arm of pedals of coupling and a brake
10.4. The main cylinder
10.5. Forward brakes
10.6. Back brakes
10.6.1. Removal and dismantling
10.6.2. Assemblage and installation
10.6.3. Check of details
10.6.4. Check of wheel cylinders of back brakes at the stand
10.7. A regulator of pressure of back brakes
10.8. A lay brake
10.9. Possible malfunctions of brakes, their reasons and elimination methods
11. An electric equipment
12. A body
13. Features of repair
14. Appendices



10.6.2. Assemblage and installation

1. Establish and fix the wheel cylinder on a brake board, attach to it a tube of a supply of a brake liquid and tighten to the full an union nut.
2. Attach to колодке the lever 2 manual drives колодок and establish brake колодки with распорной a lath 9 (fig. the Brake mechanism of a back wheel see), put racks with springs and the bottom cups.
3. Then put the top cups and fix them on racks turn in this or that party.
4. Be convinced that the ends колодок have correctly settled down in nests on pistons of the wheel cylinder and on a board.
5. Establish coupling springs колодок and attach to the lever a tip of a cable 5 manual drives колодок.
6. Establish a brake drum, preliminary having greased a landing corbel of a semiaxis and the surface of its flange adjoining to a drum, graphite greasing or greasing ЛСЦ-15, and tighten pins of fastening of a drum.
7. If at dismantling the wheel cylinder acted in film, remove air from a contour of a drive of back brakes.

«The previous page
10.6.1. Removal and dismantling
The following page»
10.6.3. Check of details