VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
3.1. Features of the device
3.2. Possible malfunctions of the engine, their reason and elimination methods
3.3. Removal and engine installation
3.4. Engine dismantling
3.5. Engine assemblage
3.6. Bench tests of the engine
3.7. Engine check on the car
3.8. The block of cylinders
3.9. Pistons and rods
3.10. A cranked shaft and a flywheel
3.10.1. Features of the device
3.10.2. Clearing of channels of system of greasing
3.10.3. Radical and шатунные necks
3.10.4. Loose leaves of radical bearings
3.10.5. A flywheel
3.10.6. Check of an axial backlash of a cranked shaft
3.11. A head of cylinders and клапанный the mechanism
3.12. A camshaft and its drive
3.13. Cooling system
3.14. Greasing system
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices



3.10.5. A flywheel


1 – a fastening surface to a flange of a cranked shaft;

2 – a surface of fastening of coupling;

3 – a basic surface of a conducted disk of coupling

1. Check up a condition of a gear wreath; in case of damage of teeths replace a flywheel.
2. The surfaces of a flywheel interfaced to cranked shaft and with the conducted disk of coupling, should be without scratches, задиров and to be absolutely flat.
3. If on a working surface 3 flywheels under a conducted disk of coupling are available scratches, pierce this surface, removing a layer of metal in the thickness no more than 1 mm. Then pierce a surface 2, having sustained the size 0,5±0,1 mm and providing parallelism of surfaces 2 and 3 concerning a surface 1. The admission непараллельности makes 0,1 mm.
4. Establish a flywheel on оправку, aligning it on a landing aperture with a stress on a surface 1, check up palpation of planes 3 and 2.
5. In extreme points the indicator should not show биений, exceeding 0,1 mm.

«The previous page
3.10.4. Loose leaves of radical bearings
The following page»
3.10.6. Check of an axial backlash of a cranked shaft