VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
12.1. Features of the device
12.2. Repair of a skeleton of a body
12.3. Paint and varnish coverings
12.4. Anticorrosive protection of a body
12.4.1. Preparation and anticorrosive processing of the latent cavities
12.4.2. Restoration of a covering of a bottom of a body and arches of wheels
12.4.3. Body hermetic sealing
12.5. Doors
12.6. A cowl, a luggage carrier cover, bumpers
12.7. Osteklenie bodies and a windscreen washer
12.8. The panel of devices
12.9. Seats
12.10. A heater
12.11. Possible malfunctions of a body, their reason and elimination methods
13. Features of repair
14. Appendices


7b94d386




12-4-2-vosstanovlenie-pokrytiya-niza-kuzova-i-arok-koles.html

12.4.2. Restoration of a covering of a bottom of a body and arches of wheels

While in service the car the anticorrosive antinoise covering on the bottom of a body from influence of gravel, sand, salt, a moisture is damaged and erased. The bared metal is exposed to corrosion.

On car factory mastic БПМ-1 is put on the bottom surface of the basis of a body and longerons for a noise isolation and protection against corrosion.

PERFORMANCE ORDER
1. Before covering restoration establish the car on the lift, carefully examine a bottom of a body and reveal defects of a covering. Clear of a dirt a body bottom, remove a rust шпателем, a skin or the rust converter according to the instruction. Blow in a body bottom the compressed air.
2. Establish the car on the lift in the chamber for drawing of mastic and remove wheels.
3. Close drums and disks of brakes protective casings, isolate a dense paper and a sticky tape карданную transfer, the muffler, cables and other places which are not subject to processing by mastic.
4. Degrease the rags moistened in uajt-spirite, the places smoothed out to metal. On the smoothed out places put a spray or a brush ground ГФ-073 and sustain 5–10 minutes
5. On defective places dispersion or manually (a brush and шпателем put mastic БПМ-1 a layer of 1-1,5 mm.
6. In a cold season mastic before the use sustain in a warm premise before rise in temperature not more low 20 ° With.
7. The thickened mastic dilute ксилолом to 3 %.
8. The paint and varnish covering polluted by mastic, clear the rags moistened in uajt-spirite.
9. Dry mastic at temperature 100–110 ° With during 30 mines or at 18–20 ° From not less than 24 o'clock.

«The previous page
12.4.1. Preparation and anticorrosive processing of the latent cavities
The following page»
12.4.3. Body hermetic sealing