VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
12.1. Features of the device
12.2. Repair of a skeleton of a body
12.3. Paint and varnish coverings
12.4. Anticorrosive protection of a body
12.5. Doors
12.6. A cowl, a luggage carrier cover, bumpers
12.7. Osteklenie bodies and a windscreen washer
12.8. The panel of devices
12.9. Seats
12.10. A heater
12.10.1. Removal and installation
12.10.2. Dismantling and assemblage
12.11. Possible malfunctions of a body, their reason and elimination methods
13. Features of repair
14. Appendices



12.10.1. Removal and installation

Drive of management of a heater

1 – draught of management of a cover воздухопритока;
2, 5, 7 – clamping скобы;
3, 8 – covers of draughts;
4 – an arm of fastening of a cover of draught;
6 – draught of management of the heater crane;
9 – a spring nut right fastenings of an arm of control levers;
10 – the screw of fastening of an arm;
11 – an arm of control levers;
12 – control levers;
13 – handles of levers


1. Translate to the full to the right a control lever the crane of a heater and merge a liquid from system of cooling of the engine.
2. Disconnect a wire "weight" from the storage battery.
3. Ослабьте coupling collars also disconnect from heater branch pipes rubber hoses for a supply and liquid tap, and then remove a rubber sealant of tubes.
4. Ослабьте a bolt скобы 7 (the Drive of management of a heater), fixing flexible draught 6 fig. see the crane, and remove draught from the crane.
5. Take away and remove four spring скобы and, having disconnected wires, remove a casing of the fan from a casing of a radiator of a heater.
6. Remove a combination of devices and through an aperture for it in the panel of devices ослабьте the screw скобы 2 which flexible draught of 1 management of a hatch cover воздухопритока fastens, and remove draught with рычажка.
7. Turn away a nut of fastening of a casing of a radiator and remove it.

At отворачивании by one of nuts of fastening of a casing of a radiator the wire of "weight" of the electric motor of the fan which is located in the left part of a casing of a radiator is disconnected.


Heater installation carry out upside-down. After installation of a heater and connection of all hoses with the engine, fill with a liquid system of cooling of the engine.

«The previous page
12.10. A heater
The following page»
12.10.2. Dismantling and assemblage