VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
4.1. The power supply system
4.2. The carburettor
4.2.1. Features of the device
4.2.2. Idling adjustment
4.2.3. Installation of level of fuel in поплавковой to the chamber
4.2.4. Adjustment of a drive of the carburettor
4.2.5. Removal and carburettor installation on the car
4.2.6. Carburettor dismantling
4.2.7. Clearing and check of a technical condition
4.2.8. Carburettor assemblage
4.2.9. Adjustment and check of the carburettor after assemblage
4.2.10. Release of the fulfilled gases
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386







4-2-5-snyatie-i-ustanovka-karbyuratora-na-avtomobile.html

4.2.5. Removal and carburettor installation on the car

Drive of management of the carburettor

1 – cross-section draught;
2 – longitudinal draught;
3 – скоба draught fastenings;
4 – a cable of management air заслонкой;
5 and 7 – уплотнители;
6 – the cable handle;
8 – a lock washer;
9 – a management pedal throttle заслонками;
10 and 17 – returnable springs;
11 – the lever;
12 – the platen;
13 – an arm of fastening of the platen;
14 – the lever;
15 – the intermediate lever;
16 – the screw of a returnable spring

PERFORMANCE ORDER
1. Remove the air filter.
2. Disconnect from the lever of a drive throttle заслонки draught 1 and a returnable spring 17. Disconnect from the carburettor a cable 4 drives air заслонки.
3. Disconnect from the carburettor hoses. The ends of hoses of a supply of fuel and cooling liquid close stoppers not to admit fuel and liquid leak.
4. Remove the carburettor. Close заглушкой an entrance aperture of the inlet pipeline.
5. Carburettor installation carry out in an order, the return to removal. After installation adjust a drive throttle заслонок the carburettor, and also engine idling.

«The previous page
4.2.4. Adjustment of a drive of the carburettor
The following page»
4.2.6. Carburettor dismantling