< Idling adjustment. VAZ 2101, 2102 (Zhigulis)
 
VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
4.1. The power supply system
4.2. The carburettor
4.2.1. Features of the device
4.2.2. Idling adjustment
4.2.3. Installation of level of fuel in поплавковой to the chamber
4.2.4. Adjustment of a drive of the carburettor
4.2.5. Removal and carburettor installation on the car
4.2.6. Carburettor dismantling
4.2.7. Clearing and check of a technical condition
4.2.8. Carburettor assemblage
4.2.9. Adjustment and check of the carburettor after assemblage
4.2.10. Release of the fulfilled gases
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices







4-2-2-regulirovka-kholostogo-khoda.html

4.2.2. Idling adjustment

Screws of adjustment of system of idling of the carburettor

1 – the screw of quantity of a mix;

2 – the screw of structure (quality) of a mix

Elements of adjustment of idling of the engine include the screw 2 defining structure of a mix, and the screw 1 regulating quantity of a mix. That the owner did not break factory adjustment, on screws 1 and 2 напрессованы the restrictive plastic plugs, allowing to turn screws only on a half-turn. If with plugs it is not possible to adjust the maintenance WITH in the fulfilled gases unscrewing screws, break heads of plugs, turn out screws, remove from them plugs and again wrap screws in the carburettor.


The prevention

At factory establish plugs of dark blue colour, and at servicing deports – red.


Idling adjustment spend on the heated-up engine (temperature of a cooling liquid 90–95 ° With and oils 75–90 °) with the adjusted backlashes in the mechanism газораспределения and with correctly established corner of an advancing of ignition.

PERFORMANCE ORDER
1. The screw 1 establish on a tachometre of the stand frequency of rotation of a cranked shaft of 820-900 mines-1.
2. The screw 2 achieve concentration (led 20 ° With and 1013 ГПа (760 mm hg)) WITH in the fulfilled gases within 0,5–1,2 % at the given position of the screw 1.
3. The screw 1 restore frequency of rotation of a cranked shaft to 820–900 mines-1.
4. If necessary the screw 2 restore concentration WITH to 0,5–1,2 %.
5. Напрессуйте on screws restrictive plastic plugs, focusing шлицы plugs concerning adjusting ledges as it is specified in drawing.

«The previous page
4.2.1. Features of the device
The following page»
4.2.3. Installation of level of fuel in поплавковой to the chamber





http://b3-b4.ru/