VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
10.1. Features of the device
10.2. Check and adjustment of brakes
10.3. An arm of pedals of coupling and a brake
10.4. The main cylinder
10.5. Forward brakes
10.5.1. Clearing
10.5.2. Removal and installation
10.5.3. Dismantling and assemblage
10.5.4. Check of details
10.5.5. Check of palpation of a brake disk
10.5.6. Replacement brake колодок
10.6. Back brakes
10.7. A regulator of pressure of back brakes
10.8. A lay brake
10.9. Possible malfunctions of brakes, their reasons and elimination methods
11. An electric equipment
12. A body
13. Features of repair
14. Appendices



10.5.2. Removal and installation

The brake mechanism of a forward wheel

1 – the union for drive prorolling
The brake mechanism;
2 – a connecting tube of working cylinders;
3 – the piston of the wheel cylinder;
4 – a clamp of the wheel cylinder;
5 – brake колодка;
6 – a sealing ring;
7 – a dustproof cap;
8 – fastening fingers колодок;
9 – a bolt of fastening of a support to an arm;
10 – a rotary fist;
11 – an arm of fastening of a support;
12 – a support;
13 – a protective casing;
14 – шплинт;
15 – a clamping spring колодки;
16 – brake колодки;
17 – the wheel cylinder;
18 – a brake disk


1. Lift a forward part of the car, establish it on supports and remove a wheel.
2. Turn away the union, disconnect from a highway a flexible hose of a brake; muffle apertures of a hose and a steel tube to prevent leak of a brake liquid.
3. Having taken out шплинты 14, and then fingers 8 with springs, remove springs 15 and brake колодки 16. Колодки mark, that at assemblage to establish on former places.
4. Having unbent lock plates, turn away two bolts 9 with which the support fastens to an arm, and remove a support 12.

The prevention

Removal of the brake mechanism (without a brake disk) in gathering with brake колодками is supposed. Thus it is enough to disconnect a hose of a support and to turn away bolts of 9 fastenings of a support.


1. Installation of a support of the brake mechanism is spent to sequences, return to removal.
2. After installation restore liquid level in a tank and pump over system for air removal.

«The previous page
10.5.1. Clearing
The following page»
10.5.3. Dismantling and assemblage