VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
9.1. Features of the device
9.2. Survey, check and steering adjustment
9.3. The steering mechanism
9.4. Draughts and spherical hinges of a steering drive
9.4.1. Removal and installation
9.4.2. Check and repair
9.5. An arm of the pendular lever
9.6. Possible malfunctions of a steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386




9-4-1-snyatie-i-ustanovka.html

9.4.1. Removal and installation

Removal of spherical fingers of draughts of a steering trapeze

1 – a key nut;

2 – stripper А.47052;

3 – the spherical hinge;

4 – the right lever of a rotary fist

PERFORMANCE ORDER
1. Расшплинтуйте also turn away a nut with which spherical fingers of lateral draughts fasten to rotary levers.
2. Stripper А.47052 take out spherical fingers from conic nests on levers.
3. Расшплинтуйте also turn away a nut of fastening of spherical fingers of average and lateral bent for сошке and to the pendular lever. Using stripper А.47035, take out fingers from corresponding nests on levers and remove draughts.
4. Installation of draughts of a steering make in an order, the return to removal.
5. All nuts of spherical fingers tighten динамометрическим a key with the subsequent шплинтовкой. If nut cut does not coincide with an aperture for шплинта a nut tighten on a corner, smaller 60 °, for maintenance шплинтовки.
6. After installation of draughts adjust a convergence of forward wheels.

«The previous page
9.4. Draughts and spherical hinges of a steering drive
The following page»
9.4.2. Check and repair