VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
11.1. Electric equipment schemes
11.2. Illumination and the light alarm system
11.3. Sound signals
11.4. A screen wiper
11.5. The heater electric motor
11.6. Control devices
11.6.1. Removal and installation of a combination of devices
11.6.2. Dismantling and assemblage of a combination of devices
11.6.3. A technique of search of malfunctions of devices
11.6.4. Check of devices
11.6.5. Check of gauges of control devices
12. A body
13. Features of repair
14. Appendices


7b94d386 На сайте http://www.canmaster.kz намотка одометра.
реферат без плагиата
Перегон машин в европу здесь.
Лучшая Стоматология в москве здесь.
автошкола Онлайн - цены на обучение 2019 автошкола Онлайн.





11-6-kontrolnye-pribory.html

11.6. Control devices

The removed combination of devices

1 – the holder

Cтрелками cartridges of control lamps and a lamp of illumination of a combination of devices (average above) are shown.

PERFORMANCE ORDER
1. Cautiously a screw-driver uncover radio receiver nests on the panel of devices either a wire hook or a screw-driver remove left дефлектор systems of heating of salon.
2. Unbend the right spring holder 1 and push out a combination of devices from a nest. In case of damage of the right holder unbend left to which it is possible to steal up a hand from under the panel of devices at the removed block of safety locks.
3. Disconnect from a combination of devices plug колодки a plait of wires and a flexible shaft of a drive of a speedometer, preliminary having turned away a nut of fastening of a flexible shaft.
4. Installation of a combination of devices make upside-down.

The prevention

At removal of a combination of devices pay attention to how the flexible shaft of a drive of a speedometer has been laid, and at installation of a combination of devices arrange a flexible shaft on a former line, without supposing its bends in radiuses less than 100 mm.



«The previous page
11.5.2. Possible malfunctions of the electric motor of a heater
The following page»
11.6.1. Removal and installation of a combination of devices