VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
11.1. Electric equipment schemes
11.2. Illumination and the light alarm system
11.3. Sound signals
11.4. A screen wiper
11.5. The heater electric motor
11.6. Control devices
11.6.1. Removal and installation of a combination of devices
11.6.2. Dismantling and assemblage of a combination of devices
11.6.3. A technique of search of malfunctions of devices
11.6.4. Check of devices
11.6.5. Check of gauges of control devices
12. A body
13. Features of repair
14. Appendices


7b94d386 футбольный клуб колос
1хбет Линия онлайн.
тренажеры для фитнес клубов, профессиональные тренажеры.
Шары для боулинга на заказ, разовая рассылка.
Kit force trx.





11-6-1-snyatie-i-ustanovka-kombinacii-priborov.html

11.6.1. Removal and installation of a combination of devices

The removed combination of devices

1 – the holder

Cтрелками cartridges of control lamps and a lamp of illumination of a combination of devices (average above) are shown.

PERFORMANCE ORDER
1. Cautiously a screw-driver uncover radio receiver nests on the panel of devices either a wire hook or a screw-driver remove left дефлектор systems of heating of salon.
2. Unbend the right spring holder 1 and push out a combination of devices from a nest. In case of damage of the right holder unbend left to which it is possible to steal up a hand from under the panel of devices at the removed block of safety locks.
3. Disconnect from a combination of devices plug колодки a plait of wires and a flexible shaft of a drive of a speedometer, preliminary having turned away a nut of fastening of a flexible shaft.
4. Installation of a combination of devices make upside-down.

The prevention

At removal of a combination of devices pay attention to how the flexible shaft of a drive of a speedometer has been laid, and at installation of a combination of devices arrange a flexible shaft on a former line, without supposing its bends in radiuses less than 100 mm.



«The previous page
11.6. Control devices
The following page»
11.6.2. Dismantling and assemblage of a combination of devices