|
4-2-4-regulirovka-privoda-karbyuratora.html
4.2.4. Adjustment of a drive of the carburettorDetails of a cover of the carburettor
1 – the adjusting screw;
2 – a starting arrangement cover;
3 – a spring;
4 – a diaphragm;
5 – a diaphragm rod;
6 – the starting arrangement case;
7 – telescopic draught;
8 – an axis air заслонки;
9 – air заслонка;
10 – a carburettor cover; |
11 – a lining;
12 – the filter;
13 – a filter stopper;
14 – a saddle of the needle valve;
15 – the needle valve;
16 – a float axis;
17 – a float;
18 – a lining;
19 – draught of the starting arrangement |
At completely pressed pedal 9 throttle заслонка the primary chamber it should be completely open and the lever throttle заслонки should not have an additional course. At the released pedal throttle заслонка should be completely closed. If it is not present to co-ordinate position of a pedal and throttle заслонки it is possible change of length of draught 2, curtailing or навертывая its tip. Simultaneously check up and if necessary adjust length of draught 1. The Mezhtsentrovoe distance of its tips should be 80 mm.
The cable and its cover is necessary for fixing so that at completely extended handle 6 air заслонка has been completely closed, and at the drowned handle – it is completely open.
| 