VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
7.1. Coupling
7.2. A transmission
7.3. Kardannaja transfer
7.4. The back bridge
7.4.1. Features of the device
7.4.2. Removal and installation of the back bridge
7.4.3. Dismantling and assemblage of the back bridge
7.4.4. Check of a beam of the back bridge
7.4.5. Editing of a beam of the back bridge
7.4.6. Semiaxes
7.4.7. A reducer
7.4.7.1. Definition of malfunctions of a reducer on noise
7.4.7.2. Reducer removal
7.4.7.3. Reducer installation
7.4.7.4. Reducer dismantling
7.4.7.5. Check of a technical condition of details of a reducer
7.4.7.6. Reducer assemblage
7.4.8. Differential assemblage
7.4.9. Installation and adjustment of a leading gear wheel
7.4.10. Adjustment of bearings of a leading gear wheel
7.4.11. Installation of a box of differential
7.4.12. A tightness of bearings of a box of differential and adjustment of a lateral backlash
7.4.13. Check of contact of teeths of gear wheels of the main transfer
7.4.14. Replacement of an epiploon of a leading gear wheel
7.4.15. Possible malfunctions of the back bridge
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386







7-4-7-5-proverka-tekhnicheskogo-sostoyaniya-detalejj-reduktora.html

7.4.7.5. Check of a technical condition of details of a reducer

Before survey of a detail of a reducer carefully wash out. It will facilitate revealing of deterioration and damage of details.

PERFORMANCE ORDER
1. Check up, whether is not present on teeths of gear wheels of the main transfer of damages and whether contact stains on working surfaces of teeths are correctly located. At inadmissible deterioration of a detail replace new; if gearing wrong, find the reason.
The prevention

In spare parts leading and conducted gear wheels are delivered by the complete set which has been picked up for noise and contact, therefore at damage of one gear wheel both replace.


2. Check up a condition of apertures of satellites and surfaces of their axis; at insignificant damages of a surface grind a fine-grained skin, and at serious damages of a detail replace new.
3. Check up surfaces of necks of gear wheels of semiaxes and their landing apertures in a differential box, eliminate damages, as well as to the previous operation.
4. Examine surfaces of basic washers of gear wheels of semiaxes, even insignificant damages eliminate. At replacement of the washers, new select for a thickness.
5. Examine roller bearings of a leading gear wheel and a differential box; they should be without deterioration, with smooth working surfaces. Replace bearings at the slightest doubt in their working capacity, the bad condition of bearings can cause noise and jamming of teeths.
6. Check up, whether is not present on картере and on a box of differential of deformations or cracks, if necessary, replace their new.
7. Carefully examine an epiploon of a leading gear wheel. At detection even insignificant damages or at deterioration of a working edge on width to 1 mm and more replace an epiploon new.

«The previous page
7.4.7.4. Reducer dismantling
The following page»
7.4.7.6. Reducer assemblage