VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
11. An electric equipment
12. A body
12.1. Features of the device
12.2. Repair of a skeleton of a body
12.3. Paint and varnish coverings
12.4. Anticorrosive protection of a body
12.5. Doors
12.6. A cowl, a luggage carrier cover, bumpers
12.7. Osteklenie bodies and a windscreen washer
12.8. The panel of devices
12.8.1. Removal and installation
12.9. Seats
12.10. A heater
12.11. Possible malfunctions of a body, their reason and elimination methods
13. Features of repair
14. Appendices


7b94d386







12-8-panel-priborov.html

12.8. The panel of devices

The panel of devices consists of a metal skeleton on which the power absorbing and decorative covering is put.

The panel of devices and its accessory

1 – an ashtray;
2 – a facing framework of control levers a heater;
3 – facing of panels;
4 – a cover of a ware box;
5 – a loop of a ware box;
6 – the panel of devices;
7 – a pipe дефлектора;
8 – дефлектор;
9 – боковина a ware box;
10 – the case of a ware box

To a body the panel fastens in eight points: from above nuts; from below screws.

Removal of the panel of devices

By arrows fastening points to cross-beams передка are shown.

PERFORMANCE ORDER
1. Disconnect a wire "weight" from the storage battery.
2. Turn out screws of fastening and remove a facing casing of a shaft of a steering, an overlay of racks of a windscreen.
3. Remove a combination of devices (subsection 11.6.1 see), the three-keyboard switch and the switch of a heater of salon.
4. Disconnecting wires from a lamp of illumination of a ware box, turn away fastening screws боковины a ware box to the panel of devices.
5. Turn out four screws of the bottom fastening of the panel of devices to a cross-beam передка. Through apertures of a ware box and a combination of devices turn away four nuts of the top fastening of the panel to передку.
6. Remove handles from control levers for what in a junction of the handle with the lever unbend the flat thin tool at the top handle the bottom part, and at bottom – top.
7. Remove the panel of devices.
8. Installation of the panel of devices is spent upside-down.

«The previous page
12.7.4. Removal and installation of jets of a washer of a windscreen
The following page»
12.8.1. Removal and installation