VAZ 2101, 2102
1. Specifications
2. Operation and service
3. The engine
4. Fuel system
5. Ignition system
6. Start and gymnastics system
7. Transmission
8. A running gear
9. A steering
10. Brake system
10.1. Features of the device
10.2. Check and adjustment of brakes
10.2.1. Check of pipelines and connections
10.2.2. Adjustment of a free wheeling of a pedal of a brake
10.2.3. Adjustment of a lay brake
10.2.4. Check of working capacity of a regulator of pressure
10.2.5. Adjustment of position of a regulator of pressure
10.2.6. Removal of air from a hydrodrive of brakes
10.2.7. Backlash adjustment between колодками and a drum
10.3. An arm of pedals of coupling and a brake
10.4. The main cylinder
10.5. Forward brakes
10.6. Back brakes
10.7. A regulator of pressure of back brakes
10.8. A lay brake
10.9. Possible malfunctions of brakes, their reasons and elimination methods
11. An electric equipment
12. A body
13. Features of repair
14. Appendices


7b94d386







10-2-4-proverka-rabotosposobnosti-regulyatora-davleniya.html

10.2.4. Check of working capacity of a regulator of pressure

PERFORMANCE ORDER
1. Establish the car on the lift or a viewing ditch, clear a regulator of pressure and a protective cover of a dirt.
2. Cautiously remove a protective cover from a pressure regulator, remove the rests of greasing and clear connection "torsion-piston".
3. Ask the assistant to press a pedal of a brake with effort 686–784 Н (70–80 кгс) and simultaneously observe of acting part of the piston of a regulator of pressure.
4. If the piston moves concerning the case of a regulator of pressure upon 0,5–0,9 mm, twisting thus торсионный the lever the pressure regulator is efficient. Repeat 2–3 times pressing a pedal completely to be convinced of working capacity of a regulator of pressure.
5. If by pressing a pedal the piston remains motionless that specifies on приржавление the piston to the case replace a pressure regulator.
6. Having convinced of working capacity of a regulator of pressure and in absence of a leak of a brake liquid between the piston and the case of a regulator of pressure, cover with a layer of greasing ДТ-1 an axis and an acting part of the piston, put 5–6 г this greasing in a rubber cover and establish a cover into place.

«The previous page
10.2.3. Adjustment of a lay brake
The following page»
10.2.5. Adjustment of position of a regulator of pressure